Installation Instructions

FormNo.3427-844RevA

RearScreenKit

Outcross9060SeriesTractionUnit

ModelNo.07532

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Screensupport

Screen

Washer6

Nut6

Bolt12

Grommet

Installtherearscreen.

Note:Youcaninstallthiskitwiththestandardbedorcargobed(optionalkit;seeyourauthorizedT oro

distributor)equipped.

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurface.

2.ShifttotheNEUTRALposition.

3.Loweranyequippedattachments.

4.Engagetheparkingbrake.

5.Shutofftheengineandremovethekey.

6.Ifyouareinstallingthiskitonamachinewithacab,performthefollowingstep:

•Cabmachinesequippedwiththestandardbed:Removethestandardbed;refertothemachine

Operator’sManual.

•Cabmachinesequippedwiththecargobed:Raisethecargobed;refertothebed-operation

instructionsinthecargobedInstallationInstructions.

Note:ThisstepallowsyoutoinstallthehardwaretothecenterbedchannelasshowninFigure2.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3427-844*A

PAGE 1
Form No. 3427-844 Rev A Rear Screen Kit Outcross 9060 Series Traction Unit Model No. 07532 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine. 2 Screen support Screen Washer Nut Bolt Grommet 3 1 6 6 12 2 Install the rear screen. Note: You can install this kit with the standard bed or cargo bed (optional kit; see your authorized Toro distributor) equipped.
PAGE 2
Installing the Rear Screen Parts needed for this procedure: 3 Screen support 1 Screen 6 Washer 6 Nut 12 Bolt 2 Grommet 3. Use 6 bolts to secure the screen supports to the bed (Figure 2). Procedure 4. Insert grommet into each screen opening (Figure 3). 1. g256134 Figure 2 1. Bolt 2. Bed-channel hole Insert the screen supports into the bed channels (Figure 1). g255614 Figure 1 1. Screen support 2. Standard bed g256131 Figure 3 2. 1.
PAGE 3
g256132 Figure 4 1. Bolt 2. Washer 7. 3. Nut If you are installing this kit on a machine with a cab, perform the following step: • Cab machines equipped with the standard bed: Install the standard bed; refer to the machine Operator’s Manual. • Cab machines equipped with the cargo bed: Lower the cargo bed; refer to the bed-operation instructions in the cargo bed Installation Instructions.
PAGE 4