Installation Instructions

FormNo.3426-471RevA

PintleHitch

Outcross9060SeriesTractionUnit

ModelNo.07536

InstallationInstructions

Installation

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurface.

2.Ensurethatthetransmissionisinneutral.

3.Lowerallattachments(ifequipped).

4.Engagetheparkingbrake.

5.Shutofftheengineandremovethekey.

RemovingtheDrawbar

fromtheMachineand

RemovingtheExisting

HammerStrap

NoPartsRequired

Procedure

1.Removethedrawbarfromthemachine;referto

themachineOperator’sManual.

2.Removetheexistinghammerstrap,washers,

andbolts(Figure1).

Note:Retaintheremovedhammerstrap,

washers,andbolts.

g261154

Figure1

1.Hammerstrap3.Washer

2.Drawbar4.Bolt

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3426-471*A

PAGE 1
Form No. 3426-471 Rev A Pintle Hitch Outcross 9060 Series Traction Unit Model No. 07536 Installation Instructions 2 Installation 1 Preparing the Machine No Parts Required Removing the Drawbar from the Machine and Removing the Existing Hammer Strap No Parts Required Procedure 1. Park the machine on a level surface. 2. Ensure that the transmission is in neutral. 3. Lower all attachments (if equipped). 4. Engage the parking brake. 5. Shut off the engine and remove the key. Procedure 1.
PAGE 2
. 3 Tighten the bolt and jam nut on each side of the hitch mount (Figure 3). Installing the Pintle Hitch Parts needed for this procedure: 1 Pintle hitch 1 Hitch mount 1 Clevis pin 1 Hairpin cotter 4 Hex-head bolt (1/2 x 2 inches) 4 Split washer 4 Hex nut (1/2 inch) Procedure 1. Secure the hitch mount to the drawbar using the clevis pin and hairpin cotter (Figure 2). g261937 Figure 3 1. Bolt 3. 2.
PAGE 3
Operation 4 Operating the Attachment Installing the Drawbar to the Machine Refer to the attachment Operator’s Manual for proper towing and operating instructions. Securing the Attachment No Parts Required 1. Remove the hitch-lock pin (A of Figure 5). Procedure 2. Open the pintle hitch (B of Figure 5). Secure the drawbar hitch to the machine; refer to the machine Operator’s Manual. 3. Secure the attachment and close the pintle hitch (C of Figure 5). 4.
PAGE 4