Installation Instructions

FormNo.3451-166RevA

SideViewMirrorKit

Workman

UTXPassengerUtilityVehicle

ModelNo.08140

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Mirror2

Mirrorbracket2

Torx-headscrew(M8x16mm)

Installthemirrors(formachineswithoutacabinstalled).

Mirror2

Torx-headscrew(M8x16mm)

Installthemirrors(formachineswithacabinstalled).

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.ShiftthetransmissionlevertotheP(Park)position.

3.Shutofftheengineandremovethekey.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3451-166*

PAGE 1
Form No. 3451-166 Rev A Side View Mirror Kit Workman® UTX Passenger Utility Vehicle Model No. 08140 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Mirror Mirror bracket Torx-head screw (M8 x 16 mm) Mirror Torx-head screw (M8 x 16 mm) 2 2 8 2 4 Prepare the machine. Install the mirrors (for machines without a cab installed). Install the mirrors (for machines with a cab installed).
PAGE 2
Installing the Mirrors Machines without a Cab Installed 1. Secure the mirror to the mirror bracket using 2 torx-head screws (Figure 1). g377324 Figure 1 2. Secure the mirror assembly to the ROPS bracket using 2 torx-head screws (Figure 2). g377325 Figure 2 2 3. Torque each screw to 26 N∙m (228 in-lb). 4. Repeat this procedure on the other side of the machine.
PAGE 3
Installing the Mirrors 2. Secure the mirror to the door using 2 torx-head screws (M8 x 16 mm) as shown in Figure 4. Machines with a Cab Installed 3. Torque each screw to 26 N∙m (228 in-lb). 1. Remove the existing 2 torx-head screws, 2 washers, and 2 locknuts (6 mm) from the cab door (Figure 3). g376338 Figure 4 4. g376295 Figure 3 3 Repeat this procedure on the other side of the machine.
PAGE 4