Installation Instructions

ManualsBrandsToro ManualsVehicles27in Alloy Wheels and Tires Kit, Workman UTX Passenger Utility Vehicle

FormNo.3449-713RevA

27inAlloyWheelsandTiresKit

Workman

UTXUtilityVehicle

ModelNo.08144

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Nopartsrequired

–

Removetheexistingwheels.

Frontwheelassembly2

Rearwheelassembly2

Lugnut16

Installthenewwheels.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3449-713*

Summary of content (8 pages)

PAGE 1
Form No. 3449-713 Rev A 27in Alloy Wheels and Tires Kit Workman® UTX Utility Vehicle Model No. 08144 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. No parts required – Remove the existing wheels. Front wheel assembly Rear wheel assembly Lug nut 2 2 16 Install the new wheels. © 2022—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Register at www.
PAGE 2
Preparing the Machine 1. Park the machine on a level surface. 2. Shift the transmission lever to the P (Park) position. 3. Shut off the engine and remove the key. 4. Raise the machine using a jack and support the machine using jack stands. The jacking point at the front of the machine is located at the front frame bottom plate. When jacking up the front of the machine, always place a wooden block (or similar material) between the jack and the machine frame. DANGER g365613 1.
PAGE 3
Removing the Existing Wheels Remove the 4 existing lug nuts and wheels from the machine.
PAGE 4
Installing the New Wheels 1. Install the 2 front wheel assemblies and 2 rear wheel assemblies using the provided 4 lug nuts on each wheel.
PAGE 5
2. Using a thin wall socket, torque the lug nuts in a crossing pattern to 108 N∙m (80 ft-lb). g383546 3. Adjust the tire pressure on each wheel assembly to the manufacturer’s recommendation. 4. After the first 10 hours of use, inspect and retorque the wheel lug nuts.
PAGE 6
Notes:
PAGE 7
Notes:
PAGE 8