Operator's Manual

ManualsBrandsToro ManualsAttachmentsSpring Tine Toolbar, Sand Pro/Infield Pro 3040 and 5040 Traction Unit

FormNo.3354-287RevC

SpringTineToolbar

SandPro

andIneldPro

3040and5040TractionUnits

ModelNo.08733—SerialNo.260000001andUp

InstallationInstructions

Important:ThetractionunitmustbeequippedwiththeMid-mountToolbarSystem,Model08731,

beforeinstallingthisattachment.

Safety

SafetyandInstructionalDecals

Safetydecalsandinstructionsareeasilyvisibletotheoperatorandarelocatednearanyareaof

potentialdanger.Replaceanydecalthatisdamagedorlost.

93-6687

1.Donotstephere.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (4 pages)

PAGE 1
Form No. 3354-287 Rev C Spring Tine Toolbar Sand Pro® and Infield Pro® 3040 and 5040 Traction Units Model No. 08733—Serial No. 260000001 and Up Installation Instructions Important: The traction unit must be equipped with the Mid-mount Toolbar System, Model 08731, before installing this attachment. Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 93-6687 1.
PAGE 2
Installation 3. Replace the pivot tube bracket with a saddle bracket and secure it to the frame with the bolts and nuts previously removed (Figure 2). 1 4. Repeat steps 2 through 3 for the other end of the pivot tube. Mounting the Spring Tine Toolbar to the Mid-Mount Toolbar System 5. Mount a guard to the outside of each saddle bracket with 2 bolts and nuts (Figure 2). Position the guards so that the decals face up. Parts needed for this procedure: 7.
PAGE 3
Figure 2 1. Saddle bracket 2. Guard 3. Extension spring 8. Install the toolbar into the mid-mount toolbar system saddles as described in step 6 in the Mid-mount Toolbar System Installation Instructions. 9. When finished, hook the long end of the extension spring to the tab on the tool bar spring bracket (Figure 2). 10. Connect the toolbar lift pedal and adjust the toolbar as described in step 7 in the Mid-mount Toolbar System Installation Instructions.
PAGE 4
Toro General Commercial Products Warranty A Two-Year Limited Warranty Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial Product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).