Form No. 3354-285 Rev B QAS Utility Box For Sand Pro® 3040 & 5040 Model No. 08760—Serial No. 260000001 and Up Register your product at www.Toro.
Introduction Figure 2 Read this information carefully to learn how to operate and maintain your product properly and to avoid injury and product damage. You are responsible for operating the product properly and safely. 1. Safety alert symbol This manual uses 2 other words to highlight information. Important calls attention to special mechanical information and Note emphasizes general information worthy of special attention. You may contact Toro directly at www.Toro.
Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 112–0006 1. Warning—read the Operator’s Manual. 2. Falling hazard—do not carry passengers in the utility tote. 3. Hot surface/burn hazard—stay a safe distance from the hot surface. 4. Tipping hazard—keep loads less than 100 lbs (45 kg). 106-5517 1. Warning—do not touch the hot surface.
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Step 1 2 3 Use Qty. Description Utility box assembly 1 Mount the utility box assembly No parts required – Adjust the link assembly No parts required – Remove the utility box The traction unit must be equipped with the Front Weight Kit, Part No. 100–6442. 2. Remove any attachment from the rear of the machine. 3. Lower the traction unit adapter.
Step Step 2 3 Adjusting the Link Assembly Removing the Utility Box No Parts Required No Parts Required Procedure Procedure 1. With the attachment mounted and secured on the traction unit, raise the attachment. 1. Drive the machine to a level surface. 2. Measure the gap between the top washer and the spacer in the link assembly on the attachment adapter as shown in Figure 5. 3. Set the parking brake and turn off the engine. Remove the key from the ignition switch. 2.
Operation • 5.5 cases of aluminium canned beverages. • For the following soil types and similar fill, load 3 inches deep (1 to 1–1/2 5 gallon pails full): Operating Tips – Wet earth containing clay • Do not carry loads which exceed the load limit of 100 pounds. • The utility box is intended for load carrying purposes only, not for passengers. • Reduce the weight of the load when operating on hills and rough terrain to avoid tipping or overturning.
Inspection and Clean-up When the operation is completed, clean the box and the machine thoroughly. Since this machine is used primarily in sand, and sand is extremely abrasive, the sand should be flushed off after each use. If the machine is cleaned frequently, before the sand has a chance to cake, it can be cleaned with a stream of water from a hose with the nozzle removed. A high pressure stream could drive the sand into wear areas where it could act as a grinding compound.
Maintenance Greasing the Attachment Adapter If the locking lever on the attachment adapter does not pivot freely and easily, apply a light coat of grease to the area shown in Figure 7.
The Toro General Commercial Products Warranty A Two-Year Limited Warranty Conditions and Products Covered The Toro® Company and its afliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial Product (“Product") to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs rst.
