Operator's Manual

1
MountingtheCrossTube
Assembly
Partsneededforthisprocedure:
1
Crosstubeassembly
4
Screw(3/8x3inch)
4Flatwasher
4
Locknut(3/8inch)
Procedure
Note:IftheSandProtractionunitisequippedwiththe
mid-mounttoolsystem,removethefastenerssecuringthe
saddlebracketandfootguards(ifsoequipped)toeachside
ofthemachine.Removeanddiscardthesaddlebrackets,foot
guardsandfasteners(Figure3).Supportthemid-mounttool
systemtopreventitfromlowering.
Figure3
1.Saddlebracket
2.Footguard
1.Fromtheleftsideofthemachine,slidethecrosstube
assemblyunderthemachine,aligningthemounting
bracketholeswiththeholesineachframetube(Figure
4).
Figure4
1.Crosstubeassembly
2.Securethecrosstubemountingbracketstotheframe
tubeswith4screws(3/8x3inch),4atwashers,and4
locknuts(3/8inch);refertoFigure4.
2
InstallingtheCutter-Head
Assembly
Partsneededforthisprocedure:
1
Cutter-headassembly
1Hitchpin
Procedure
1.Slidethepivottubeofthecutterheadontothecross
tube(Figure5).
7