Addendum

FormNo.3448-397RevA

RearRemoteHydraulicKit

SandPro

/IneldPro

3040and5040TractionUnit

ModelNo.08781—SerialNo.315000001andUp

Addendum

ThisaddendumisforSandProModels08703and08705.

YouwillnotusethefollowingpartstoinstallthiskitonSandPromodels08743and08745:

Description

Quantity

Dipstick1

Valveplate1

Thread-formingscrew(5/16x3/4inch)

Bolt(1/4x1-3/4inches)

Youwillneedtouselongerboltstoinstallthevalves.Order2bolts(1/4x3inches—PartNo.321–23);

refertoyourauthorizedTorodistributor.

Setup

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Valve1

Bolt(1/4x3inches)

Nut(1/4inch)

Small90-degreeelbow

Teetting

Teeadapter1

Relay1

Cap

Installthemanifoldandbracket.

Thisprocedurereplacestheexisting“InstallingtheValve”(Number6)procedureinyourkitInstallation

Instructions(FormNo.3416-266).

8111LyndaleAvenueSouth

Bloomington,MN55420Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3448-397*

PAGE 1
Form No. 3448-397 Rev A Rear Remote Hydraulic Kit Sand Pro®/Infield Pro® 3040 and 5040 Traction Unit Model No. 08781—Serial No. 315000001 and Up Addendum This addendum is for Sand Pro Models 08703 and 08705. You will not use the following parts to install this kit on Sand Pro models 08743 and 08745: Description Quantity Dipstick 1 Valve plate 1 Thread-forming screw (5/16 x 3/4 inch) 2 Bolt (1/4 x 1-3/4 inches) 2 You will need to use longer bolts to install the valves.
PAGE 2
Installing the Valve Note: Make sure that all O-rings are lubricated and properly positioned on all fittings before installation. Note: Install all fittings and hydraulic lines loosely first and then tighten them when everything is installed. Install the fittings at the angles shown in the figures. 1. Park the machine on a level surface, engage the parking brake, shut off the engine, and remove the key. 2. Install the fittings at the angles shown in the figures.