Form No. 3362-479 Rev C Synthetic Turf Conditioner Sand Pro®/Infield Pro® with QAS Model No. 08790—Serial No. 290000001 and Up To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com.
Contents This product complies with all relevant European directives, for details please see the separate product specific Declaration of Conformity (DOC) sheet. Introduction................................................................. 2 Setup............................................................................ 3 1 Mounting the Conditioning Brushes to the Traction Unit.................................................... 3 2 Adjusting the Link Assembly.............................. 4 Operation..
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 Frame assembly Flange head screw, 1/2 x 2 inch Lock nut, 1/2 inch Brush Plastic spacer Bolt, 5/8 x 3–1/2 inch Washer 1 4 4 4 4 8 8 Mount the conditioning brushes to the traction unit. 2 No parts required – Adjust the link assembly. Media and Additional Parts Description Use Qty.
6 1 2 3 5 2 3 7 8 10 9 G012712 Figure 2 1. Frame channel 2. Capscrew, 5/8 x 3–1/2 inch 3. Washer 4. Flange head bolt, 1/2 x 2 inch 5. Lock nut, 1/2 inch 6. Attachment adapter 7. Plastic spacer 10. Left brush 8. Right brush 9. Center brush 7. Mount the frame assembly to the attachment adapter with (4) 1/2 x 2 inch flange head bolts and lock nuts (Figure 2). 2 8. Place the brushes and the plastic spacers (one each) under the frame channel mounting holes.
Operation Note: The gap between the washer and the shoulder should be 0.060 to 0.080 inch (Figure 3). Read this entire section on conditioning before actually working on turf. There are many conditions that will determine the adjustments necessary. Make the adjustments on the rake for optimum results in your particular area. Training Period Practice conditioning before moving onto the turf. Practice starting and stopping, turning, raising and lowering the conditioner. Practice at a slow ground speed.
Conditioning Pattern • Change the dragging pattern occasionally to prevent grain in the turf. • Never groom perpendicular to the seams. • The recommended pattern for conditioning sports field is shown in Figure 4. • Lower the conditioner and travel in straight lines. • Always raise the conditioner when turning. • Drag the conditioner in alternating directions keeping in mind the direction of seams.
Maintenance Greasing the Attachment Adapter If the locking lever on the attachment adapter does not pivot freely and easily, apply a light coat of grease to the area shown in Figure 5.
Toro General Commercial Products Warranty A Two-Year Limited Warranty Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial Product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).
