Form No. 3362-481 Rev B Synthetic Turf Conditioner Tow-Behind Accessory Model No. 08791—Serial No. 290000001 and Up To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com.
Contents Introduction Introduction................................................................. 2 Safety ........................................................................... 3 Safety and Instructional Decals ............................. 3 Setup............................................................................ 4 Assembling the Synthetic Turf Conditioner...................................................... 4 Operation....................................................................
Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 114-0645 1. Maximum braking weight is 52 lb. (23 kg); maximum tongue weight is 413 lb. (187 kg). 114-0646 1. Warning—keep bystanders a safe distance from the brush.
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Description Tongue Bolt, 1/2 x 2 inch Washer Clevis pin, 1/2 x 1–1/2 inch Hair pin cotter Clevis pin, 3/4 x 3–1/2 inch Use Qty. 1 2 2 1 2 1 Assembling the synthetic turf conditioner Media and Additional Parts Description Use Qty.
2. Secure the clevis link to the tongue mounting tab with a 1/2 x 1–1/2 inch clevis pin and hair pin cotter (Figure 3). Figure 3 Some brushes removed for clarity 1. Hair pin cotter 2. Clevis link 3. Clevis pin 3. Attach the tongue to the tow vehicle hitch with a 3/4 x 3–1/2 inch clevis pin and hair pin cotter (Figure 4). Figure 4 1. Tow vehicle hitch 2. Clevis pin 3. Tongue 4. Hair pin cotter Figure 5 1. Positive power cord (+) 4. Carefully route the power cord and rocker switch to the tow vehicle.
Figure 6 1. Battery cover 9. Using the rocker switch, lower the brushes to the ground. 10. Rotate the clevis link assembly (Figure 3) right or left until the front and rear brushes contact the ground with equal pressure. 11. Tighten all the bolts firmly. Check tightness of all hardware after first use, and check periodically thereafter.
Conditioning Pattern Operation • Never groom perpendicular to the seams. Read this entire section on conditioning before actually working on synthetic turf. There are many conditions that will determine the adjustments necessary. Make the adjustments on the brushes for optimum results in your particular area. • Always raise the conditioner when turning. Training Period • Drag the conditioner in alternating directions keeping in mind the direction of seams.
Figure 7 Inspecting and Cleaning the Conditioner and Traction Unit When the conditioning operation is completed, clean the machine thoroughly with water to remove debris from the brushes.
Maintenance Lubrication Lubricate the wheel lift frame grease fittings (Figure 8) after the machines initial set up and then annually with No. 2 General Purpose Lithium-Base Grease. If the machine is used in extremely dirty and dusty conditions, lubricate the bearings more frequently. g011929 Figure 8 To lubricate the machine, complete the following procedures: 1. Wipe the grease fittings clean so foreign matter cannot be forced into the bearings. 2.
Notes: 10
Notes: 11
