Installation Instructions

FormNo.3446-738RevA

BrushKitforToothRake

SandPro

ModelNo.08816—SerialNo.400000000andUp

InstallationInstructions

Installation

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurfaceandlowertheattachment.

2.Engagethemachineparkingbrake.

3.Shutofftheengineandremovethekey.

4.Waitforallmovingpartstostopbeforeleavingtheoperator’sseat.

5.UsingthedimensionsshowninFigure1,locate,mark,anddrill4holeswitha8.7mm(11/32inch)

diameterbitthroughthetopwallofthetoptubeofthetoothrake.

Note:Youcanalsousethebracketsasdrillingtemplatesoncetheyareinstalledonthebrush(Figure2).

g354466

Figure1

1.6.0cm(2.37inches)fromtheendofthetoptube3.69.4cm(27.31inches)tothenextsetofholes

2.7.7cm(3.03inches)betweenholes4.Drill4holeswitha8.7mm(11/32inch)diameterbitateach

markedlocation

8111LyndaleAvenueSouth

Bloomington,MN55420Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3446-738*

PAGE 1
Form No. 3446-738 Rev A Brush Kit for Tooth Rake Sand Pro® Model No. 08816—Serial No. 400000000 and Up Installation Instructions Installation 1 Preparing the Machine No Parts Required Procedure 1. 2. 3. 4. 5. Park the machine on a level surface and lower the attachment. Engage the machine parking brake. Shut off the engine and remove the key. Wait for all moving parts to stop before leaving the operator’s seat. Using the dimensions shown in Figure 1, locate, mark, and drill 4 holes with a 8.
PAGE 2
Installing the Brush Kit Parts needed for this procedure: 1 Brush assembly 2 Brush bracket 4 Carriage bolt (5/16 inch) 4 Locknut (5/16 inch) 4 Self-tapping screw g354481 Figure 3 3. Procedure 1. Loosely mount the brush brackets to the brush assembly with 4 carriage bolts and nuts (Figure 2). g354480 Figure 2 1. Brush bracket 2. 2. Brush assembly Mount the brush brackets to the tooth rake with 4 self-tapping screws (Figure 3).