Installation Instructions

Printed in the USA

 2004 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Brush Kit for Tooth Rake

Sand Pro

Model No. 08816–240000001 & Up

Form No. 3351–479

Installation Instructions

1. Using the dimensions shown in figure 1, locate, mark

and drill (4) .348 in. dia. holes thru one wall of top

tube in tooth rake.

2.37”

3.030”

27.312”

3.030”

.348” dia. (4)

Figure 1

2. Loosely mount the brush brackets to the brush/brush

support with (4) carriage bolts and nuts (Fig. 2).

Figure 2

1. Brush/Brush support 2. Brush bracket

3. Mount the brush brackets to the tooth rake with (4) self

tapping screws (Fig. 3). Tighten the carriage bolts and

nuts securing the brush bracket to the brush/brush

support (Fig. 2).

Figure 3

PAGE 1
Form No. 3351–479 Brush Kit for Tooth Rake Sand Pro Model No. 08816–240000001 & Up Installation Instructions 1. Using the dimensions shown in figure 1, locate, mark and drill (4) .348 in. dia. holes thru one wall of top tube in tooth rake. 3.030” .348” dia. (4) 27.312” 3.030” 2.37” Figure 1 2. Loosely mount the brush brackets to the brush/brush support with (4) carriage bolts and nuts (Fig. 2). 3. Mount the brush brackets to the tooth rake with (4) self tapping screws (Fig. 3).