Operator's Manual
!
Remove foot from traction pedal, make sure pedal
is in neutral position and engage parking brake.
Push choke forward to ON position - when
starting a cold engine - and throttle lever to SLOW
position.
Insert key into ignition switch and rotate it
clockwise to start the engine. Release key when
engine starts. Regulate the choke to keep engine
running smoothly.
1 23(7(05 17(3+($5,0* 1) 5+( 45$35(3
/1513 '1 015 (0*$*( 45$35(3 .10*(3 5+$0
4(&10'4 )5(3 4(&10'4 1) &105,06164 &3$0-,0*
8$,5 4(&10'4 %()13( (0*$*,0* 45$35(3 /1513
$*$,0
When engine is started for the first time, or after
overhaul of the engine, operate the machine in forward
and reverse for one to two minutes. Also operate the lift
lever to be sure of proper operation of all parts. Shut
engine off and check for oil leaks, loose parts and any
other noticeable malfunctions.
!
+65 (0*,0( 1)) $0' 8$,5 )13 $.. /17,0*
2$354 51 4512 %()13( &+(&-,0* )13 1,. .($-4
.114( 2$354 $0' 15+(3 /$.)60&5,104
To stop engine, move throttle control to SLOW
position and rotate ignition key to OFF. Remove key
from switch to prevent accidental starting.
Close fuel shut off valve before storing machine.
#
The purpose of the interlock system is to prevent the
engine from cranking or starting unless the traction
pedal is in NEUTRAL".
+( ,05(3.1&- 48,5&+ ,4 )13 5+( 12(3$5134
2315(&5,10 41 '1 015 ',4&100(&5 ,5 +(&-
12(3$5,10 1) 5+( 48,5&+ '$,.: 51 $4463(
,05(3.1&- 4:45(/ ,4 12(3$5,0* ) 5+( 48,5&+
,4 '()(&5,7( 3(2.$&( ,5 %()13( 12(3$5,0*
(*$3'.(44 ,) 48,5&+ ,4 12(3$5,0* 2312(3.:
13 015 3(2.$&( ,5 (7(3: 581 :($34 51 $4463(
/$9,/6/ 4$)(5: 1 015 3(.: (05,3(.: 10
4$)(5: 48,5&+(4 64( &1//10 4(04(
!
Check interlock operation in a wide open area free
of debris and bystanders. Stop engine.
Sit on the seat. Depress traction pedal in forward
and reverse directions, while trying to start the engine.
If engine cranks there may be a malfunction in the
interlock system. Repair immediately. If engine does
not crank, system is operating correctly.
"
In case of emergency, the SAND PRO can be towed for
a short distance. However, Toro does not recommend
this as a standard procedure.
Do not tow the machine faster than
2-3 mph because drive system may be damaged. If
machine must be moved a considerable distance,
transport it on a truck or trailer. Tires may lock up if
machine is towed too fast. If this occurs, stop towing
machine and wait for traction circuit pressure to
stabilize before resuming towing at a slower speed.
Only 8 hours operating time is required for SAND
PRO break-in period.
Since the first hours of operation are critical to
future dependability of the machine, monitor its
functions and performance closely so that minor
difficulties, which could lead to major problems, are
noted and can be corrected. Inspect SAND PRO
frequently during break-in for signs of oil leakage,
loose fasteners, or any other malfunction.
!4,0* 5+( /$&+,0( '(/$0'4 $55(05,10 1
23(7(05 5,22,0* 13 .144 1) &10531. 64(
&$3( 8+(0 (05(3,0* $0' .($7,0* 4$0'
53$24 !4( (953(/( &$65,10 $3160'
',5&+(4 &3((-4 13 15+(3 +$;$3'4 !4(
&$65,10 8+(0 12(3$5,0* /$&+,0( 10 $
45((2 4.12( ('6&( 42((' 8+(0 /$-,0*
4+$32 56304 13 8+(0 5630,0* 10 +,..4,'(4
71,' 46''(0 45124 $0' 45$354 1 015 *1
)31/ 3(7(34( 51 )6.. )138$3' 8,5+165 ),345
&1/,0* 51 $ &1/2.(5( 4512
!
Practice driving the SAND PRO because its operating
characteristics are different than some utility vehicles.
Two points to consider when operating the vehicle are
transmission and engine speed.