Operator's Manual
&$
Change oil initially after the first 8 hours of operation,
thereafter change oil every 50 hours and filter every 100
hours.
Park the machine on a level surface and turn the
engine off.
Remove drain plug and let oil flow into drain pan.
When oil stops, install drain plug.
Remove oil filter. Apply a light coat of clean oil to the
new filter gasket.
Screw filter on by hand until gasket contacts filter
adapter, then tighten 1/2 to 3/4 turn further. DO NOT
OVER-TIGHTEN.
Add oil to crankcase, refer to CHECK
CRANKCASE OIL, Page 10.
Dispose of oil properly.
&$/,"
, &) +'/$
&' #&'.",
&$
Inspect paper element every 100 hours of operation
and replace every 400 hours or when dirty or
damaged. Do not wash paper element or do not clean
with compressed air as damage will occur.
Park the machine on a level surface and turn the
engine off.
Pivot seat upward.
Remove knobs and air cleaner cover.
Remove filter and cover plate. Inspect filter for
cleanliness, ruptures, holes, and tears. Replace
defective filter element.
*." With air cleaner disassembled, check air cleaner
components for damage. Replace if necessary. Make
sure rubber breather tube in base plate is securely in
place or severe engine damage may occur. Also, make
sure carburetor breather hose is routed out through
engine vents.
&$/,"
&, !'" )", !*0",
+", "'"(").
Reinstall air cleaner and cover plate.
Reinstall air cleaner cover and secure with knobs.
&$
Inspect the dust cup once a week or every 50 hours
operation. However, daily or more frequent inspection
is required when operating conditions are extremely
dusty and dirty.
Release latches securing air cleaner cover to air
cleaner body. Separate cover from body. Clean inside
of air cleaner cover.
&$/,"
&, !'" )", ' .!%"-
/-. !/+
&'.",
ÇÇ
ÇÇ