Operator's Manual
"
$ # !$!" -+
Whenever a hydraulic component is repaired or
replaced the hydraulic oil filter should be changed and
hydraulic system charged.
"" %/) 685) ,;(5%80-' 5)6)593-5 -6 *-00)(
:-7, 3-0 %7 %00 7-1)6 :,)2 ',%5+-2+ ,;(5%80-'
6;67)1
Park the machine on a level surface and turn the
engine off.
Remove (3) screws securing side panel to right
side of machine and remove panel.
Loosen lock nut on spring adjusting pin until
bearing moves freely from cam on lever, allowing pump
shaft freedom to rotate during start-up.
Raise one rear wheel off floor and place support
blocks under frame.
Start engine and set throttle to allow engine to run
at slow idle approximately 1800 rpm.
-+85)
!45-2+ %(.867-2+ 4-2
)%5-2+
%1
Actuate the lift valve lever until the lift cylinder rod
moves in and out several times. If cylinder rod does not
move after 10-15 seconds or pump emits abnormal
sounds, shut the engine off immediately and
determine cause or problem. Inspect for the following:
Loose filter or suction lines.
Blocked suction line.
Faulty charge relief valve.
Faulty charge pump.
If cylinder moves in 10-15 seconds, proceed to
step 7.
37) ,;(5367%7-' 75%261-66-32 6)59-') 1%28%0
&800)7-2 3 %2( % 5)4%-5 1%28%0 &800)7-2 3
'%2 &) 3&7%-2)( *531
!82(675%2( 35435%7-32
%67 7, !75))7
1)6 3:%
Operate the traction pedal in forward and reverse
directions. If wheel rotates in proper direction, stop
engine and adjust the spring adjusting pin lock nut.
Adjust traction neutral position: refer to Adjusting
Traction Drive For Neutral, page 22.
#!" !" -+
Place the front wheel in the straight ahead position.
Adjust the locknuts until the chain is snug on both
sides of sprocket.
-+85)
(.867-2+ 2876
Turn the steering wheel full left and full right to be
sure the chain does not bind or hang up in either
direction. Readjust as required.
# " -+
An in-line filter is incorporated into the fuel line
between the fuel tank and carburetor. Replace the filter
every 800 hours or sooner if fuel flow is restricted. Be
sure the arrow on the filter is pointing away from the fuel
tank (toward carburetor).
Remove (3) screws securing side panel to left side
of machine and remove panel.
Close fuel shut off valve, loosen the hose clamp on
the carburetor side of filter and remove the fuel line
from the filter.
Place a drain pan under filter, loosen the remaining
hose clamp and remove filter.
Install the new filter with arrow on the filter body
pointing away from the fuel tank (toward carburetor).