Operator's Manual
+)63'
6'. +.5'3
14' .#/24
!
+)
If the machine creeps" when the traction pedal is in
the neutral position, the traction cam must be adjusted.
Park the machine on a level surface and turn the
engine off.
Remove (3) screws securing side panel to right
side of machine and remove panel.
Raise one rear wheel off floor and place support
blocks under frame.
Loosen locknut on traction adjustment cam.
+)63'
3#%5+10 #&,645/'05 %#/
Start engine and rotate cam hex in both directions
to determine mid position of neutral span.
"
0)+0' /645 $' 3600+0) 41 (+0#. #&,645/'05 1(
5*' 53#%5+10 #&,645/'05 %#/ %#0 $' 2'39
(13/'& 1 )6#3& #)#+045 2144+$.' 2'3410#.
+0,638 -''2 *#0&4 (''5 (#%' #0& 15*'3 2#354 1(
5*' $1&8 #7#8 (31/ 5*' /6((.'3 15*'3 *15 2#354
1( 5*' '0)+0' #0& 15*'3 315#5+0) 2#354
Tighten locknut securing adjustment.
Stop the engine. Remove jack stands and lower
the machine to the shop floor. Test drive the machine to
make sure it does not creep.
"
+)
The pedal must be adjusted for forward if jam nuts on
control rod are loosened or if pedal is removed.
Park the machine on a level surface and turn the
engine off.
Make sure pump is in neutral.
Loosen jam nuts on control rod.
Press down on forward pad of pedal until pedal rod
contacts footrest. Tighten jam nuts.
+)63'
10531. 31&
"
!
+)
If steering wheel tilt lever does not lock after adjusting
wheel position an adjustment to the lever is required.
Loosen capscrew securing lever to locking pin.
Lift lever off hex on locking pin. Rotate lever
counterclockwise to next hex on pin.
Push lever onto locking pin hex and secure with
capscrew.
Check adjustment and repeat if necessary.