Operator's Manual
! & " ! !%!! !%#'$
!%!! #"&#
Check Battery Fluid Level
Check Battery Cable Connections
{ Change Engine Oil
Lube Front Wheel Bearing
Lube Traction Control Linkage
Replace Engine Oil Filter
Inspect Remote Air Filter Element
Inspect Engine Air Filter Element
Lube Steering Shaft Grease Fitting
Check Steering Chain Adjustment
{ Torque Wheel Lug Nuts
Change Hydraulic Oil
{ Replace Hydraulic Oil Filter
Replace Remote Air Filter Element
Replace Engine Air Filter Element
Replace Spark Plugs
Replace Fuel Filter
De-carbon Combustion Chamber
Adjust Valves and Torque Head
Check Engine RPM (idle and full throttle)
Drain and Clean Fuel Tank
{ Initial break in at 8 hours
Replace Moving Hoses
Replace Traction Safety Switch
Every
25hrs
Every
100hrs
Every
400hrs
Every
800hrs
!%!! !%#' #'
!!& " !%"!$
Items listed are recommended every 1500
hours or 2 years, whichever occurs first.
The SAND PRO 5020 has two identification numbers: a
model number and a serial number. These numbers
are stamped into a plate located on left frame rail. In
any correspondence concerning the unit, supply the
model and serial numbers to ensure correct
information and replacement parts are obtained.
"% Do not order by reference number if a parts
catalog is being used; use the part number.
To order replacement parts from an authorized TORO
Distributor, supply the following information:
Model and serial numbers.
Part number, description, and quantity of parts
desired.