Operator's Manual
.-%(&41 3(.- Tricycle vehicle with welded steel
frame construction. Rear engine placement. All wheels
powered.
-&(-$: Briggs & Stratton, V-twin cylinder, 4 cycle,
OHV, air cooled, gas engine with cast iron sleeves. 18
hp @ 3600 rpm, 34.8 cu. in. (570 cc) displacement,
1.75 qt. oil capacity. Electronic ignition. Full pressure
lubrication, oil filter. Engine and remote mounted air
cleaners.
4&$ Hour meter.
.-31.+2 Hand operated throttle, choke, lift lever and
parking brake. Foot pedal controls traction forward /
reverse speed.
3$$1(-& Front wheel steering with adjustable tilt
steering wheel.
2 -* 5.5 gallon capacity.
33$17 12 volt, lead acid, 280 CCA.
1(5$ Hydraulic. Coupling driven variable
displacement piston pump with integral auxiliary
charge pump to hydraulic motors which directly drive
wheels.
7#1 4+(" (+ (+3$1 25 micron, spin on type.
7#1 4+(" (+ $2$15.(1 3 gallon capacity.
+5$ Single section for raising and lowering of
implement with float.
7+(-#$1 Double acting.
(1$2 22 x 11.00 - 8 two ply pneumatic tubeless.
De-mountable and interchangeable. Recommended
tire pressure is 4 PSI.
/$$#2 3 Variable between 0 and 11
MPH forward and 0 and 4 MPH reverse.
$ 3 #)423,$-3 4 inches - fore and aft. Additional
1.75 inches forward adjustment available by using
front mounting holes. Additional adjustment for small
operator attained by removing seat slides and base
and mounting seat directly to support.
(,$-2(.-2
Width w/o implements: 58"
Width w/rake Model 08812: 75"
Height: 45.25"
Length w/o implements: 64.5"
Wheelbase 42.75"
Net Weight: (Wet) 810 lb.
/3(.- + 04(/,$-3
Drag Mat Model No. 08845
Rake Mounting Kit Model No. 08814
Tooth Rake Model No. 08812
Weeder/Cultivator Model No. 08815
Finish Grader Model No. 08867
Spiker Model No. 08856
Front Blade Model No. 08821
Spring Rake Model No. 08813
Hitch Part No. 92-2380
.3$ Use this chart as a checklist to ensure all parts necessary for assembly have been shipped. If any of these
parts are missing, total set-up cannot be completed.
Tire & rim assembly 2 Install on rear motors
Lug nuts 8
Steering wheel 1 Mount steering wheel
Roll pin 1/4 x 2" lg. 1
Capscrew 1/4 - 20 x 5/8" lg. 2 Secure battery cables to battery
Nuts 1/4 - 20 2
Capscrew 1/2 - 13 x 1-1/4" lg. 4 Mount rear attachments
Washer 1/2 4
Cylinder pin 1
Hairpin cotter 2 Attach cylinder to implement
Capscrew 3/8 - 16 x 2-1/4" lg. 1
Locknut 3/8 - 16 1
Spacer 1
Keys 2
Decals 2 Affix on machine, if desired
Operator's manual 1 Read before operating machine.
Parts catalog 1
Registration card 1 Fill out and return to Toro.
/$"(%(" 3(.-2 -# #$2(&- 24!)$"3 3. "' -&$ 6(3'.43 -.3("$