Operator's Manual
" ,*
15( Install the rear wheels to the machine while it is
still on the pallet shipping blocks.
Mount a wheel to each wheel motor and secure
with lug nuts. Tighten lug nuts evenly and gradually in a
crisscross manner to 45-55 ft-lb.
,*63(
($3 8+((.
Remove the shipping blocks and lower the
machine onto the rear wheels.
15( We suggest saving the shipping blocks, as they
are the correct height for blocking the unit when
changing tires, servicing wheel motors or performing
other service work.
" ,*
Move front wheel so it points straight ahead.
Slide steering wheel onto steering shaft aligning
mounting holes.
Secure steering wheel in place with roll pin.
,*63(
5((3,0* 8+((.
1.. 2,0
! # ,*
Pivot seat upward and engage seat prop.
Remove (2) wing nuts and washers securing top
battery hold down to side battery hold downs. Remove
top battery hold and remove battery.
$55(3:
14,5,7( %$55(3: 5(3/,0$.
(*$5,7( %$55(3: 5(3/,0$.
12 %$55(3: +1.' '180
,*63(
! #
If Battery is not filled with electrolyte or activated,
bulk electrolyte with 1.260 specific gravity must be
purchased from a local battery supply outlet and
added to battery.
"($3 4$)(5: *1**.(4 $0' 36%%(3 *.17(4
8+(0 813-,0* 8,5+ (.(&531.:5( +$3*( 5+(
%$55(3: ,0 $ 8(.. 7(05,.$5(' 2.$&( 41 *$44(4
231'6&(' 8+,.( &+$3*,0* &$0 ',44,2$5(
,0&( 5+( *$4(4 $3( (92.14,7( -((2 12(0
).$/(4 $0' (.(&53,&$. 42$3- $8$: )31/ 5+(
%$55(3: '1 015 4/1-( $64($ /$: 3(46.5
,) 5+( *$4(4 $3( ,0+$.(' 02.6* &+$3*(3
)31/ (.(&53,&$. 165.(5 %()13( &100(&5,0* 51
13 ',4&100(&5,0* &+$3*(3 .($'4 )31/ %$5;
5(3: 21454
Remove filler caps from battery and slowly fill each
cell until electrolyte is up to fill line.
Replace filler caps and connect a 3 to 4 amp
battery charger to the battery posts. Charge the battery
at a rate of 3 to 4 amperes for 4 to 8 hours.