Operator's Manual
When battery is charged, disconnect charger from
electrical outlet and battery posts. Allow battery to sit
for 5 to 10 minutes before proceeding to next step.
Remove filler caps and slowly add electrolyte to
each cell until level is up to fill line. Install filler caps.
: . -.2 .4$0%(++ ! 22$06 +$"20.+62$ 5(++
.4$0%+.5 .-2. .2'$0 / 021 .% 2'$ , "'(-$ -#
1$4$0$ ".00.1(.- -# #$2$0(.0 2(.- 5(++ 0$13+2
(&
Slide the battery in place, with the terminals to the
outside.
Secure the positive cable (red) to the positive (+)
terminal with a 1/4-20 x 5/8" lg. capscrew and nut.
.--$"2(-& " !+$1 2. 2'$ 50.-& /.12
".3+# 0$13+2 (- /$01.- + (-)306 -#.0
# , &$ 2. 2'$ $+$"20(" + 1612$, *$
130$ ! 22$06 .0 " !+$1 #. -.2 (-2$0%$0$ .0
03! .- -6 ,.4(-& .0 '.2 / 021
Secure the two small black wires and the negative
cable (black) to the negative (-) terminal of the battery
with a 1/4-20 x 5/8" lg. capscrew and nut.
Coat the terminals and mounting fasteners with
petroleum jelly to prevent corrosion. Slide the rubber
boot over the positive (+) terminal to prevent possible
short-out from occurring.
Install the top battery hold down to side battery
hold downs and secure with washers and wing nuts.
Release seat prop and lower seat.
Affix a Infield Pro decal over each Sand Pro decal, if
desired.