Service Manual

Starting Problems (continued)
Problem Possible Causes
Engine cranks, but does not start. Circuit wiring to engine magneto is grounded (see
Chapter 9 – Electrical Diagrams).
Circuit wiring to carburetor solenoid is loose, corroded
or damaged (see Chapter 9 – Electrical Diagrams).
Engine stop relay is faulty
.
Ignition switch is faulty.
Engine or fuel system is malfunctioning (see Chapter
3 – Engine).
Engine may be too cold.
General Run Problems
Problem Possible Causes
Battery does not charge. Wiring to the charging circuit components is loose,
corroded or damaged (see Chapter 9 – Electrical
Diagrams).
Ignition switch is faulty.
Battery is faulty.
Engine alternator is faulty (see Chapter 3 – Engine).
Engine kills during operation. Interlock switch on handle is not depressed.
Ignition switch is faulty.
Engine stop relay is faulty.
Interlock switch(es) on handle is/are faulty.
Coring head switch(es) is/are faulty.
Circuit wiring to engine magneto is damaged (see
Chapter 9 – Electrical Diagrams).
Circuit wiring to carburetor solenoid is loose, corroded
or damaged (see Chapter 9 – Electrical Diagrams).
Engine or fuel system is malfunctioning (see Chapter
3 – Engine).
Electrical System
Page 5 – 4
Greens Aerator