Service Manual

Adjustments

Adjust Shift Tower

If the shift tower on the front of the aerator frame is not

positioned correctly, the shift lever will not properly en-

gage the transaxle gears. Perform the following proce-

dure to position the shift tower is transaxle shifting is

difficult.

1. Park machine on a level surface, fully raise coring

head, stop engine and remove key from the ignition

switch.

2. Raise lock–up brackets on each side of machine and

lower coring head until it rests on brackets.

3. Position shift lever into the neutral slot in shift tower

4. Loosen four (4) cap screws, flat washers and lock

nuts that secure shift tower to machine (Fig. 1).

5. While rotating drive pulley on transaxle, adjust posi-

tion o

f shift lever and shift tower until sprockets on trans-

axle output shafts do not move.

6. Secure shift tower in position with four (4) cap

screws, flat washers and lock nuts.

Figure 1

1. Shift tower 3. Flat washer (4 used)

2. Cap screw (4 used) 4.

Lock nut (4 used)

Greens Aerator Page 7 – 3 Drive Train

Drive Train