Service Manual

Jacking Instructions

CAUTION

jack stands, the machine may move or fall,

Jacking the Front End

ing.

Figure 1

When changing attachments, tires or perform-

ing other service, use correct blocks, hoists

and jacks. Make sure machine is parked on a

solid level surface such as a concrete floor.

Prior to raising machine, remove any attach-

ments that may interfere with the safe and prop-

raising of the machine. Always chock or

block wheels. Use jack stands or solid wood

blocks to support the raised machine. If the ma-

chine is not properly supported by blocks or

which may result in personal injury.

1. Chock rear tires to prevent the machine from mov-

2. Raise lock–up brackets on each side of machine and

lower coring head until it rests on brackets (Fig. 1).

3. Position jack securely under the front of the frame on

side of machine (Fig. 2).

1. Lock–up bracket (raised position)

Figure 2

4. Jack front of machine off the ground.

1. Front wheel 2. Frame jacking point

5. Position jack stands or hardwood blocks under the

front of the frame to support the machine.

6. Repeat jacking and support on other side of frame.

Jacking the Rear End

1. Chock front tire to prevent the machine from moving.

2. Raise lock–up brackets on each side of machine and

lower

coring head until it rests on brackets (Fig. 1).

3. Place jack securely under the main frame just inside

of the rear wheel (Fig. 3).

4. Jack rear of machine off the ground.

Figure 3

2. Frame jacking point

5. Position jack stands or hardwood blocks under the

1. Rear wheel

frame to support the machine.

Safety

Page 1 – 4

Greens Aerator