Service Manual

Rear Wheel Hub
FRONT
RIGHT
1
2
3
4
7
6
5
10
8
9
12
13
14
11
17
16
15
18
19
20
21
24
23
22
27
25
26
29
30
31
28
32
4
4
6
24
See text for
tightening
procedure
65 to 90 ft–lb
(88 to 122 N–m)
Figure 2
1. Frame 12. Nut retainer 23. Idler cover
2. Lock nut 13. T
ab washer 24. Retaining ring
3. Sprocket guard (RH shown) 14. Cotter
pin 25. Ball bearing
4. Cap screw 15. Half
link 26. Idler sprocket
5. Shaft seal 16.
Wheel stud (4 used per hub) 27. Bushing
6. Bearing 17. Master
link 28. RH chassis guard
7. Shaft 18. Drive
chain 29. Special nut
8. Grease fitting 19. Spacer 30.
LH chassis guard
9. Hub 20. Lock
washer 31. Lug nut (4 used per hub)
10. Jam nut 21. Cap
screw 32. Rear wheel
11. Dust cap 22. Flat
washer
Removal (Fig. 2) 4. While holding idler sprocket, remove cap screw (item
21), lock washer (item 20), flat washer (item 22) and
1. Park machine on a level surface, fully raise coring
special nut (item 29) to allow idler cover (item 23) to be
head, stop engine and remove key from the ignition
removed. Reinstall cap screw
, washers and special nut
switch.
to retain idler sprocket.
2. Raise lock–up brackets on each side of machine and
5.
Remove sprocket guard (item 3) and chassis guard
lower coring head until it rests on brackets.
(item 28 or 30) from machine.
3. Remove rear wheel (see Rear Wheel Removal in
6.
Position idler sprocket to allow slack in drive chain.
this section).
Chassis Page 6 – 6 Greens Aerator
v