Service Manual

Transaxle
1
2
3
4
7
6
5
10
8
9
12
20
21
11
19
18
22
FRONT
RIGHT
8
13
14
17
16
15
16
23
24
25
26
29
28
27
30
31
Figure 7
1. Transaxle 12. Taper lock bushing 22. Spring
2. Elbow 13. Pulley 23.
Socket head screw (3 used)
3. Oil tube 14.
Lock washer (3 used) 24. Shift guide plate
4. Pyramidal washer (4 used) 15.
Cap screw (3 used) 25. Gasket (2 used)
5. Cap screw (4 used) 16. W
oodruff key 26. Roll pin
6. Set screw (2 used per sprocket) 17. Cap
screw 27. Set screw (2 used)
7. Cap screw 18. Oil
plug 28. Brake caliper
8. Lock washer 19. Pyramidal
washer 29. Brake disc
9. Thrust washer 20.
Shift lever assembly 30. Cap screws (4 used)
10. Key 21. Knob 31.
Nut (4 used)
11. Sprocket
Removal (Fig. 7) 4. Remove drive belt from machine (see Traction Drive
Belt Removal in this section).
1. Park machine on a level surface, fully raise coring
head, stop engine and remove key from the ignition 5.
Remove drive chain from both transaxle sprockets
switch. (see Drive Chain Disassembly in this section).
2. Raise lock–up brackets on each side of machine and 6.
Pull knob from shift lever.
lower coring head until it rests on brackets.
7. Support transaxle to prevent it from falling.
3. Remove brake caliper from machine (see Brake Cal-
iper Removal in Service and Repairs section of Chapter
6 – Chassis).
Drive Train
Page 7 – 8 Greens Aerator
v