Operator's Manual

10
Figure 3
1. Vented fuel tank cap
2. To prevent a fire hazard, wipe up gasoline that may
have spilled.
CHECK HYDRAULIC SYSTEM
FLUID
The hydraulic system is designed to operate on SAE 10
W-30 engine oil or, as a substitute, SAE 10 W-40 engine
oil. The machine’s reservoir is filled at the factory with
2.7 pints of SAE 10 W-30 engine oil. However, check the
level of hydraulic fluid before the engine is first started
and daily thereafter.
1. Position the machine on a level surface and raise the
coring head to the full up position.
2. Remove the dipstick cap (Fig. 4) from the filler neck
and wipe it with a clean cloth. Insert the dipstick cap
into the filler neck; then remove it and check the level
of fluid. If the level is not within 1.25 cm (
1
⁄2 inch)
from the full mark on the dipstick, add SAE 10W-30
engine oil to raise the level to full mark. Do not
overfill.
3. Install the dipstick filler cap onto the filler neck.
4. Run the engine for one minute, recheck the level of
fluid and add oil as needed.
Figure 4
1. Dip stick cap