Service Manual

Drive Belt Removal (Fig. 13)

1. Park the machine on a level surface, fully raise the

coring

head and stop the engine. Remove the key from

the ignition switch.

2. Raise lock–up brackets on each side of machine and

lower coring head until it rests on brackets.

3. Remove control cover from machine (Fig. 14).

4. Loosen two (2) self–tapping screws (item 16) that

se-

cure pump support bracket to frame. Loosen jam nut

(item 17) and then loosen square head screw (item 18)

Figure 14

to relax pump drive belt.

1. Control cover

5. Remove drive belt from hydraulic pump and engine

pulleys.

Drive Belt Installation (Fig. 13)

1. Install pump drive belt to hydraulic pump and engine

pulleys.

2. Adjust pump drive belt tension (see Operator’s

Manual).

3. Install control cover to machine (Fig. 14).

Hydraulic

System

Greens Aerator Page 4 – 17 Hydraulic System