Operator's Manual

SettingtheCoringDepth
Tosetthecoringdepthoftheaerator,proceedas
follows:
1.Selectthepreferredtineforyourapplication.
2.Laythetineonthetinedepthdecal(Figure27)with
oneendlinedupwiththedesireddepthofaeration
(refertothetineoverlayonthedecal).
1
2
Figure27
1.Aerationdepthlever
2.Overlayondecal
3.Determinewhichlettersettingtheotherendofthe
tinelinesupwithandsetthedepthcontrolleverto
thecorrespondinglettersetting.
Note:Asthetinewears,youmaybeabletoresetthe
depthsettingtoaccountforthatwear.Forinstance,if
yournewtinedepthsettinghasyouintheGsetting,
youcanresettotheHsettingafter1/4inch(6mm)
oftinewear.
SettingUpManualGround
Following
Theonlytimethemanualdepthsettingspacersare
requiredisiftheTrueCore
®
groundfollowingsystem
isnotfunctioningduetodamagetothefeedback
system(turfguards,tierod,andactuatorassembly)orif
maximumcoringdepthisrequired.‘
1.Removethelynchpinretainingthespacersand
depthpins(Figure28).
1
2
2
Figure28
1.Lynchpin
2.Spacersanddepthpin
2.Positionthespacersaboveorbelowthebracketto
attainthedesiredcoringdepth.
•Thickspacersequateto3/4inch(19mm)
increments.
•Thinspacerequatesto3/8inch(9.5mm)depth
increment.
•Withallspacersonthetopside,thedepth
settingis4-1/4inches(10.7cm).
3.Removelockingboltandnutfromselectorswitch
(
Figure29).
1
2
Figure29
1.Manualgroundfollowing
selectorswitch
2.Boltandnut
4.Rotatetheswitchtothedownpositiontoturnoff
TrueCorefeature.
5.Installthelockingboltandnuttoensurethatthe
settingisnotaccidentallychanged.
25