Operator's Manual
12
SET-UP INSTRUCTIONS
ADJUST 3 POINT LIFT STOP
Adjust and set 3 point lift stop (Fig. 12) to provide
approximately 4" ground clearance, when in the raised
position, to minimize PTO angle when raising aerator.
For transporting or trailer loading/unloading, the full lift
range can be used as long as the PTO tubes do not
slide apart. Operating the PTO in the fully raised
position may damage the PTO.
Figure 12
1. 3 Point lift stop
1
NOTE: Refer to tractor operator's manual for
adjustment procedures.
INSTALL TINES/TINE HEADS
A wide selection of tines and tine heads are available
for the aerator. Choose the tine type, size and spacings
required for the job. Install the tine head and tines per
Installation Instructions supplied with each tine kit.
Refer to accessory chart on page 14, for required tines.
IMPORTANT: Never operate the aerator without the
tine heads installed. The arms will move
excessively and may damage the aerator frame.
MOUNT TURF GUARDS
A wide selection of turf guards are available for the
aerator. Choose the required turf guards per accessory
chart on page 14.
1. Loosen nuts securing turf guard clamps to turf
finger tool bar (Fig. 13).
2. Slide appropriate turf guard under center turf
guard clamp while inserting notch onto locator key of
turf finger bracket (Fig. 13). Refer to accessory chart
note, page 14.
Figure 13
1. Turf guard
2. Turf finger tool bar
3. Turf guard clamp
1
2
3
4
5
4. Notch
5. Locator key
3. Tighten nuts securing turf guard and center turf
guard clamp to turf finger bracket.
4. Working outward, mount remaining turf guards to
each side and secure turf guard clamps.
IMPORTANT: From the rear of the machine, check that
the tines line up with the center of the gaps in the turf
guards.
5. To decrease down pressure of turf guards:
A. Remove nuts securing each end of turf finger
bracket to roller legs (Fig. 14).
B. Pivot turf finger bracket upward and insert a
spacer (washer) onto each stud.
C. Pivot turf finger downward onto studs and
check angle.
D. Install nuts to secure assembly.
NOTE: Aeration depth may need to be reduced to
assure clearance between the tine heads and the turf
guards. Check clearance before aerating.
Figure 14
1. Spacer location (1 each end)
2. Roller scraper tab
1
2