Operator's Manual

LOOSE PARTS

NOTE: Use this chart as a checklist to assure all parts have been received. Without these parts, total set-up cannot

be completed.

Note: Some parts may already be installed on machine.

PTO Drive Shaft 1 Transfers power from tractor to aerator

Rear Castor/Safety Stand 1 Supports aerator for maintenance/storage

Side Guards 2 Keeps hands and feet away from tines

Keys 2 For hood latch on TE models

Operator's Manual 2 Read Before Operating Machine

Parts Catalo

1 Service Part Identification

Description

UseQty.

SET-UP INSTRUCTIONS

TRACTOR REQUIREMENTS

 16 Horsepower

 Correct tire pressure

 Category I 3 point hitch, rated to lift at least a

1000 lb. (454 Kg) implement

 540 rpm tractor PTO

 Adequate front end weight (ballast)

BALLAST REQUIREMENTS

CAUTION

To help prevent bodily injury and provide

added stability, make sure front of tractor

is equipped with proper ballast. Refer to

tractor operator's manual for ballast re

quirements.

 Refer to Tractor Operator's Manual for ballast

requirements.

CONNECT LOWER LINK ARMS

1. Aerator must be positioned on a flat, level surface

for installation.

2. Back tractor squarely up to aerator until lower link

arms are aligned with hitch pins.

3. Make sure PTO is disengaged.

4. Engage parking brake, STOP engine and remove

key from ignition. Wait for engine and all moving parts

to STOP before leaving operator's seat on tractor.

5. Insert right and left lower link arms onto hitch pins

(Fig. 1).

Figure 1

1. Lower link

2. Lynch pin

6. Secure lower link arms to hitch pins with lynch pins

(Fig. 1).