Operator's Manual

CONTROLS

Depth Adjustment Handles (Fig. 16) - Remove lynch

pins and rotate handles to raise or lower tines to

desired depth. Replace lynch pins.

Figure 16

1. Depth adjustment handle

2. Lynch pin

Depth guides (Fig. 17) - Depth guides (1 thru 27) are

provided to give equal increments for adjustment. The

numbers do not relate to measurements of depth as

this changes with tine type and amount of tine wear.

Adjustment between two numbers will give

approximately .20 inches (5 mm) change in depth. The

higher the number, the deeper the tine penetration.

Always adjust each side to the same number.

Figure 17

1. Depth guide