Operator's Manual

18
Controls
Depth Adjustment Handles
Remove lynch pins, rotate handles to raise or lower tines
to desired depth and replace lynch pins (Fig. 17).
1
2
Figure 17
1. Depth adjustment handle 2. Lynch pin
Depth Guides
Depth guides (1 thru 27) are provided to give equal
increments for adjustment. The numbers do not relate to
measurements of depth as this changes with tine type and
amount of tine wear. Adjustment between two numbers
will give approximately .20 inches (5 mm) change in
depth. The higher the number, the deeper the tine
penetration. Always adjust each side to the same number
(Fig. 18).
1
Figure 18
1. Depth guide