Operator's Manual

Level the Aerator Side-To-Side

1. Park the tractor and aerator on a level, firm

surface.

2. Place a level on top of the aerator hood to check

for level side-to-side.

Figure 11

1. Level

3. Turn the adjustable link body (if provided) to

raise or lower the link arm until the aerator is

leveled side-to-side.

NOTE: Refer to the tractor operator’s manual for

additional adjustment procedures.

Adjust the 3-Point Lift Stop

Adjust and set the 3-point lift stop (Fig. 12) to provide

approximately 10cm (4”) ground clearance, when in

the raised position, to minimize PTO angle when

raising the aerator. For transporting or trailer

loading/unloading, the full lift range can be used as

long as the PTO tubes do not slide apart. Operating

the PTO in the fully raised position may damage the

PTO.

Figure 12

1. 3-point lift stop

NOTE: Refer to the tractor operator’s manual for

adjustment procedures.

Install Tines/Tine Heads

A wide selection of tines and tine heads are available

for the aerator. Choose the tine type, size and

spacings required for the job. Install the tine head and

tines per Installation Instructions supplied with each

tine kit. Refer to accessory chart for required tines.

: Never operate the aerator without the

tine heads installed. The arms will move excessively

and may damage the aerator frame.

Mount the Turf Guards

A wide selection of turf guards are available for the

aerator. Choose the required turf guards per accessory

chart.

1. Loosen the nuts securing the turf guard clamps to

the turf finger tool bar (Fig. 13).

2. Slide the appropriate turf guard under the center

turf guard clamp while inserting the notch onto

Important