Operator's Manual

Depth Adjustment Handles (Fig. 16)—Remove the

lynch pins, rotate the handles to raise or lower tines to

the desired depth and replace the lynch pins.

Figure 16

1. Depth adjustment handle

2. Lynch pin

Depth Guides (Fig. 17)—Depth guides (1 through

27) are provided to give equal increments for

adjustment. The numbers do not relate to

measurements of depth as this changes with tine type

and amount of tine wear. Adjustment between two

numbers will give approximately 0.2 inches (5 mm)

change in depth. The higher the number, the deeper

the tine penetration. Always adjust each side to the

same number.

Figure 17

1. Depth guide

Controls