Operator's Manual

Before Aerating
Inspect the area of operation for hazards that could
damage the machine and remove them, if possible, or
plan how to avoid them. Carry replacement tines and
tools for repairs should tines contact foreign materials.
Aerating Procedures
Note: when using needle tine heads, make sure to read
the instructions included with the kit for unique
operating procedure.
1. Lower the aerator on the 3-point linkage so that
the tines are nearly to the ground at the lowest
part of their stroke.
2. At a low tractor engine rpm, engage the power
take-off (PTO) clutch to start the aerator working.
: Do not operate the aerator at 540
PTO rpm when lifted out of the ground. This
machine can be damaged if operated at full speed
without the tines working in the turf. Never
operate the aerator without tine heads installed
3. Select a gear that gives a forward speed of
approximately 0.6–2.5 MPH (1 to 4 km/hr) at
rated PTO speed. (Refer to the tractor operator’s
manual)
4. As the clutch is released and the tractor moves
forward, lower the machine fully into work and
increase engine speed to give a maximum of 540
rpm at the PTO.
: Never operate the tractor PTO in
excess of 540 rpm or damage to the aerator could
occur.
5. Note the hole pattern. If you need greater hole
spacing, increase the tractor’s forward speed by
changing up a gear or, with a hydro-static drive
tractor, shift the hydrostat lever or pedal to give
faster speed. For closer hole spacing, decrease
tractor forward speed. Changing engine speed, in
a particular gear, WILL NOT change the hole
pattern. Operate at an engine speed in which the
aerator runs smoothly.
: Look behind frequently to ensure
the machine is operating properly and alignment
is maintained with previous passes.
6. Use the front tractor wheel as a guide to maintain
equal lateral hole spacing with the previous pass.
7. At the end of the aeration pass, raise the aerator,
lower the engine rpm and disengage the PTO.
8. If you back into a tight area (like a tee box),
disengage the PTO and raise the aerator to its
highest position. Use caution not to catch the
turf guards on the turf.
9. Always clear the area of all damaged machine
parts, such as broken tines, etc., to prevent their
being picked up by mowers or other turf
maintenance equipment.
10. Replace broken tines, inspect, and correct
damage to those still usable. Repair any other
machine damage before operating.
Transport Operation
To begin transport operation, raise the aerator and
disengage the PTO. To avoid loss of control, traverse
steep inclines slowly, approach rough areas at reduced
speed and cross severe undulations carefully.
: Do not exceed transport speeds of 15
mph (24 km/hr).
CAUTION: Do not exceed the maximum or
minimum tractor tire inflation pressures as
recommended by tire manufacturer.
Important
Important
Important
Important
23