Operator's Manual

8.Verifythatthetelescopingtubehasaminimum
of76mm(3inches)overlapwhenthemachine
israisedtothemaximumheight.
Tochecktheoverlap,measurethedistance
betweentheendshields,asshowninFigure
13.Thisdimensionmustnotexceed406mm
(16inches).Ifso,movethelowerliftpinstothe
uppersetofholesbeforeoperatingthemachine.
g007297
Figure13
1.406mm(16inches)
5
AdjustingtheSwayLinks
NoPartsRequired
Procedure
•TheProCore864isdesignedtobeoffsetfromthe
tractionunitcenterline.Thegearboxinputshaft
isoffset40mm(1.57inches)totheleftofcenter
andthemachineisoffset145mm(5.70inches)to
therightofthecenterline.Adjusttheswaylinks
asneeded.
•TheProCore1298isdesignedtobecenteredwith
thetractionunitcenterline.Adjusttheswaylinks
asneeded.
Adjusttheswaylinksonthelowerdraftarmsofthe3
pointhitchtoresistside-to-sideswaytoamaximum
of25mm(1inch)ateachside(Figure14).
g007333
Figure14
1.Swaylink(lowerdraftarm)
Adjustthelowerlinksinboarduntiltheycontactthe
machinemountingplates.Thisreducesstresson
thepins.Ifthetractionunithasswaychainsinstead
ofswaylinks,installwashersbetweenthelowerlink
armandlynchpintoreducetheoverhungloadonthe
liftpins.
Note:Refertothetractionunitoperator'smanualfor
additionalinstallationandadjustmentprocedures.
6
LevelingtheMachine
Side-to-Side
NoPartsRequired
Procedure
1.Parkthetractionunitandthemachineona
level,rmsurface.
2.Placealevelontopoftheframeofthemachine
tocheckitforlevelside-to-side(Figure15).
13