Service Manual

ProCore 864/1298 Page 3 − 7 Chassis
Removal (Fig. 5)
1. Position aerator on a firm, level surface. If attached
to tractor, disengage PTO, apply tractor parking brake,
stop engine and remove key from the ignition switch.
2. Remove rear hood.
3. To remove either pulley shield (items 2 or 3), remove
four (4) flange head screws and flat washers that secure
pulley shield to coring frame. Remove pulley shield.
4. To remove front cover (item 1):
A. Remove four (4) flange head screws and four (4)
flat washers that secure PTO shield (item 20) to front
cover. Remove PTO shield.
B. Remove one of the pulley shields (see step 3
above).
C. Remove seven (7) flange head screws and flat
washers that secure front cover to frame. Remove
front cover.
Installation (Fig. 5)
1. Make sure that tinnerman nuts (item 8) are properly
positioned to frame. Also, make sure that iso mounts
(item 6) are placed in cover holes.
2. Position front cover to aerator frame and secure with
removed fasteners. Attach PTO shield to front cover
with removed fasteners.
3. After front cover is installed, position pulley shield to
aerator frame and secure with removed fasteners.
4. Install rear hood.
Chassis