Service Manual

ProCore 864/1298 Page 3 − 9 Chassis
Removal (Fig. 6)
1. Position aerator on a firm, level surface. If attached
to tractor, disengage PTO, apply tractor parking brake,
stop engine and remove key from the ignition switch.
2. Remove rear hood.
3. To remove pulley shield (item 2), remove four (4)
flange head screws and flat washers that secure pulley
shield to coring frame. Remove pulley shield.
4. To remove front cover (item 1):
A. Remove one of the pulley shields (see step 3
above).
B. Remove five (5) flange head screws and flat
washers that secure front cover to frame. Remove
front cover.
5. To remove yoke cover (item 3), remove four (4)
flange head screws and flat washers that secure yoke
cover to hitch frame. Remove yoke cover.
Installation (Fig. 6)
1. Make sure that tinnerman nuts (item 8) are properly
positioned to machine. Also, make sure that iso mounts
are placed in cover holes.
2. Position cover to aerator frame and secure with re-
moved fasteners.
3. After front cover is installed, position shield to aerator
frame and secure with removed fasteners.
4. Install rear hood.
Chassis