Operator's Manual

Figure29
1.Locknut3.Rollerheightadjusting
nuts
2.Heightadjustingkey4.Rollerheightadjusting
plate
LevelingtheCoreProcessor
1.BeforelevelingtheCoreProcessor,makesure
thepickupbrushandtherearrollerheightare
adjustedtothecorrectheightofcut(Figure30).
IftheCoreProcessorisequippedwithanewbrush,
therearrolleradjustmenttablecanbereferencedtoset
therearrollerforpropergrassheightofcut.
Note:Atthefactorytherearrollerissetat3mm(1/8
inch)brushclearancefromtheground.
Figure30
1.Locknut3.Rollerheightadjusting
nuts
2.Heightadjustingkey4.Rollerheightadjusting
plate
Note:Thetablehasmadeaccommodationsfor2.5
cm(1inch)ofbrushwear.Replacethebrushifworn
morethan2.5cm(1inch).
2.Adjusttherearrollersothebrushissetatheightof
grassorlower.Adjusttherollerasfollows:
•Beforemakinganyadjustments,checkthebrush
heightonahardsurfacesoyoucandetermine
whichdirectionyoumayhavetoadjusttherear
roller.
•Loosenthethreeboltsoneachrollersideplate.
•Loosenthecenternutsotheadjustmentkeycanbe
pulledout.Holdrearrollerup,pulladjustmentkey
outandmoverollertodesiredheight.Bothsides
mustbeatthesameheight.
Note:Eachnotchis.6cm(1/4inch)of
adjustment
•AfterrearrollerisadjustedcheckCoreProcessor
frametobesureitisparalleltotheground.
Recheckbrushheight.
Note:Youmayhavetoreadjusttherearroller
ifyoucannotgetthemainframeparalleltothe
ground.
24