Installation Instructions

ManualsBrandsToro ManualsAerators3/4 inch Four-Tine Head, ProCore Aerator

FormNo.3386-436RevA

2x5MiniTineHead

1x6MiniTineHead

3/4inchThree-TineHead

3/4inchFour-TineHead

7/8inchThree-TineHead

NeedleTineHead

ProCore

Aerator

ModelNo.09736

ModelNo.09737

ModelNo.09739

ModelNo.09794

ModelNo.09796

ModelNo.09797

InstallationInstructions

Installation

PreparingtheCoringHead

1.Movethemachineontoalevelsurfaceandengagethe

parkingbrake.

2.DisengagedthePTO,shutofftheengine,andremove

thekeyfromtheignitionswitch.

3.Puttheaeratorintotheserviceposition;refertothe

Operator’sManual.

WARNING

Ifyouleavethekeyintheignitionswitch,someone

couldaccidentlystarttheengineandseriously

injureyouorbystanders.

Removethekeyfromtheignitionswitchbeforeyou

doanymaintenance.

Important:Theaeratormustbeequippedwiththe

properturfguardsbeforeusingthetinehead.Referto

the

Operator’ s Man ual

fortheturfguardrequirements.

Installingthe2x5or1x6Mini

TineHead

1.Insertthetineintothetineholderandsecureitwith

thesetscrew .

Figure1

1.Tineholder

4.Setscrew(3/8x5/8inch)

2.Tinearm

5.Bolt(1/2x1-1/4inches)

3.Tine

2.Torquethesetscrewsto37to45N∙m(27to33ft-lb).

3.Usethe2bolts(1/2x1-1/4inches)tosecurethetine

holdertothetinearm(Figure1).

4.Torquetheboltsto91to113N∙m(67to83ft-lb).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3386-436*A

Summary of content (2 pages)

PAGE 1
Form No. 3386-436 Rev A 2x5 Mini Tine Head 1x6 Mini Tine Head 3/4 inch Three-Tine Head 3/4 inch Four-Tine Head 7/8 inch Three-Tine Head Needle Tine Head ProCore® Aerator Model No. 09736 Model No. 09737 Model No. 09739 Model No. 09794 Model No. 09796 Model No. 09797 Installation Instructions Installation Preparing the Coring Head 1. Move the machine onto a level surface and engage the parking brake. 2. Disengaged the PTO, shut off the engine, and remove the key from the ignition switch. 3.
PAGE 2
Installing the Needle Tine Heads Installing the 3/4 inch or 7/8 inch Tine Heads 1. Use the bolts (3/8 x 1-1/2 inch) to loosely secure the tine clamp to the tine holder (Figure 2). Note: You should replace the tine clamp when you install the 5 mm tines, after using the 8 mm tines. Note: The 3 tine holder uses 4 bolts, and the 4 tine holder uses 3 bolts to secure it to the tine arm. 1. Insert needle tines into the holes in the tine holder (Figure 3). 2.