Form No. 3355–189 Rev. C HydroTote) Trailer Hydroject) Aerator Model No. 09833—Serial No.
Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Before Operating . . . . . . . . . . . . . . . . . . . . . . . . . . While Operating . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety and Instruction Decals . . . . . . . . . . . . . . . . . Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Loose Parts Chart . . . . . . . . . . . . . . . . . . .
• When turning or driving on slopes, always SLOW the tow vehicle, then turn to prevent loss of control and possible upset. • Watch out for traffic when near or crossing roads. Always yield the right of way to pedestrians and other vehicles. • DO NOT make sudden or sharp turns. DO NOT suddenly change direction of travel on an incline, ramp, grade, slope or similar surface. • If the trailer begins to vibrate abnormally, stop immediately. Shut off the tow vehicle engine.
Setup Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Chart Note: Use this chart as a checklist to ensure all parts necessary for assembly have been shipped. If any of these parts are missing, total setup cannot be completed. Description Qty. Use Frame Right axle Left axle Cradle Carriage bolt, 1/2 x 1–1/2 in.
1. Insert the right and left axles into the frame (Fig. 1). The right axle shaft is longer. 7. Mount a tongue plate to the top and bottom of the hitch tube with (2) 3/8 x 2–1/2 in. capscrews and locknuts. Position the plates as shown in figure 3. 2. Position the cradle between the axles aligning it’s mounting holes with the hoes in the axles (Fig. 1). The cradle is to be positioned so the strap hook is to the rear. 3. Secure each axle to the cradle with (2) 1/2 x 1–1/2 in. carriage bolts and nuts (Fig.
Operation Caution Note: Determine the left and right sides of the machine from the normal operating position. When loading the HydroJect, always be aware of your surroundings. DO NOT operate near bystanders or other equipment. Attach the Trailer to the Tow Vehicle • Load the HydroJect only on a level surface. Do not attempt to load the HydroJect on an incline, ramp, grade, slope or similar surface.
Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Lubrication Each trailer has (2) grease fittings (Fig. 5) that must be lubricated daily with No. 2 General Purpose Lithium Base Grease. The lubrication points are the wheel assemblies (2). Important Lubricating grease fittings immediately after washing helps purge water out of bearings and increases bearing life. 1. Wipe each grease fitting with a clean rag. 2.
The Toro General Commercial Products Warranty A Two-Year Limited Warranty Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial Product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first.
