Installation Instructions

FORM NO. 3322–562 Rev. A

36”

iller Lift Cable Kit

PART

NO. 100–1591

INSTALLATION

INSTRUCTIONS

Loose

Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Cable guide

Cable

Guard extension

Installation of kit

Installation Instructions

Read before installing

Description

This kit is designed for use on tillers, Model No.

79375 and Model No. 715704006, to prevent the lift

cable from interfering with the transaxle cooling fan.

In addition, guard extensions are provided to prevent

lift bar interference with the jack shaft pulley.

Installing

the Lift Cable

1. If the tiller is mounted on a tractor, park the unit

on a level surface and lower the tiller to the

ground. Turn the ignition to “STOP” to stop the

engine. Remove the ignition key.

2. Remove the hairpin and clevis pin from the lift

cable at the attachment lift arm (Fig. 1).

Note: Attachment lift arm may be different

than shown in Fig. 1 on some models.

m–3504

Figure 1

1. Lift

cable

2. Clevis

Attachment lift arm

Clevis pin 5/16” x 1” (25

mm)

Hairpin cotter

PAGE 1
FORM NO. 3322–562 Rev. A 36” Tiller Lift Cable Kit INSTALLATION INSTRUCTIONS PART NO. 100–1591 Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Cable guide 1 Cable 1 Guard extension 2 Installation Instructions 1 USE Installation of kit Read before installing Description This kit is designed for use on tillers, Model No. 79375 and Model No. 715704006, to prevent the lift cable from interfering with the transaxle cooling fan.
PAGE 2
Installation 3. Remove the hairpin, washer and trunnion from the tiller lift mounting bracket on the tiller. Remove the trunnion and cable assembly (Fig. 2). Measure and record the distance from the end of the cable to the trunnion to use as a reference for installing the trunnion on the new cable. Unscrew the locknut and trunnion from the lift cable. Save all parts except the lift cable. POTENTIAL HAZARD • Rotating shaft or cooling fan can cause injury. WHAT CAN HAPPEN • Fingers, hands, feet, hair, etc.
PAGE 3
Installation Instructions 6. Align the front of the cable guide with the hole in the left hand side of the plastic fan baffle and reinstall the other bolt previously removed. Tighten all bolts and nuts securely. 1. Remove the jack shaft assembly from the tractor, if installed. 2. Place a guard extension on the top forward edge of each of the two existing guards (Fig. 4). Clamp each guard extension tight against the existing guard and weld in place.
PAGE 4
Installation 4