Installation Instructions



The T

oro Company – 1999

Printed in USA

FORM NO. 3323-158

INSTALLATION

INSTRUCTIONS

Part No. 100–2439

Rear Baffle Kit

for 60I OFZ Deck

Loose

Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Baffle

Screw

Lock Nut

Install New Baf

fle

Pre–Installation

POTENTIAL HAZARD

• Blade is sharp.

WHAT CAN HAPPEN

• Contact with sharp blade can cause serious

personal injury.

HOW TO AV

OID THE HAZARD

• Wear gloves or wrap sharp edges of the

blade with a rag.

1. Disengage the power take off (PTO), set the

parking brake, and turn the ignition key to

“OFF” to stop the engine. Remove the key.

2. Tilt up deck and lock into vertical position.

3. Thoroughly clean mower deck. All debris must

be removed to ensure baffle will fit properly

against mower deck.

4. Repair all bent or damaged areas of mower deck

and replace any missing parts.

PAGE 1
FORM NO. 3323-158 Rear Baffle Kit for 60I OFZ Deck Part No. 100–2439 INSTALLATION INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Baffle 1 Screw 1 Lock Nut 1 Pre–Installation POTENTIAL HAZARD • Blade is sharp. USE Install New Baffle 1. Disengage the power take off (PTO), set the parking brake, and turn the ignition key to “OFF” to stop the engine. Remove the key. 2. Tilt up deck and lock into vertical position. 3.
PAGE 2
Installation Instructions Removing Existing Wear Plate 1. Remove existing righthand wear plate under deck. Save hardware that is removed (Fig. 1). 3 Note: When installing bolts, the bolt heads need to be on the inside of cutting deck. 2. Use the baffle as a template to drill a hole in side of deck. Mark location and drill a 11/32 in. hole. (Fig. 2). 3. Install screw and flange nut into deck and baffle. Torque to 200±25 in–lb. 4. Rotate blade to ensure it does not hit baffle.