Installation Instructions



The T

oro Company – 1999

Printed in USA

FORM NO. 3323-106

INSTALLATION

INSTRUCTIONS

Part No. 100–2441

Bagger Dump Kit

for Out Front Z

Loose

Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Dump Plate

Install Dump Plate

Hopper Floor Plate

Screw

Flat W

asher

Locknut

Install Hopper Floor

Emitter Bracket

Install Emitter Bracket

PAGE 1
FORM NO. 3323-106 Bagger Dump Kit for Out Front Z Part No. 100–2441 INSTALLATION INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY.
PAGE 2
Installation Instructions Installing Dump Plate Installing Hopper Floor Plate 1. Disengage the power take off (PTO), set the parking brake, and turn the ignition key to “OFF” to stop the engine. Remove the key. 1. Lift rear hopper door. Clean out any loose grass and debris. 2. 2. Remove the existing three bolts that hold hopper to the frame (Fig. 1). Save existing hardware. Tilt hopper floor plate at an angle to place it into the hopper. 3. Slide the dump plate under the hopper.
PAGE 3
Installation Instructions Installing New Emitter Bracket The new emitter bracket can be installed to allow an earlier signal when hopper is full. The receiver bracket must be moved also when an earlier signal is desired. Moving Receiver 1. Remove the receiver bracket from the front of hopper. Keep the receiver attached to bracket (Fig. 3). Save existing hardware. 2. Install a bolt through the bottom hole in the hopper and into the top hole of bracket (Fig. 3). The top hole in hopper is not used. 3.
PAGE 4
Installation Instructions 4