Installation Instructions

FORM NO. 3322–786

Blade Stabilizer Kit

PART

NO. 100–3367

INSTALLATION

INSTRUCTIONS

Loose

Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Stabilizer

Guide

Screw

, 3/8–16 x 1” (25 mm)

Nut, 3/8”

Screw

, 5/16–18 x 1 1/4” (32 mm)

Nut, 5/16”

Installation of kit

Installation Instructions

Read before installing

Description

This kit is designed for use with a 48” snow/dozer

blade, Model No. 79355( S/N 8900001 & up),

Model No. 716506006 (S/N T8BM0001 & up) or

95–4090 kit to stabilize the blade in a lateral

direction.

Installation

1. If the blade is installed on a tractor, park the unit

on a level surface, lower the attachment lift. Set

the parking brake and turn the ignition key to

“Stop” to stop the engine. Remove the ignition

key.

2. Remove the blade attachment from the tractor.

Refer to “Removing the Blade” in the Operator’s

Manual.

PAGE 1
FORM NO. 3322–786 Blade Stabilizer Kit INSTALLATION INSTRUCTIONS PART NO. 100–3367 Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Stabilizer 1 Guide 1 Screw, 3/8–16 x 1” (25 mm) 2 Nut, 3/8” 2 Screw, 5/16–18 x 1 1/4” (32 mm) 1 Nut, 5/16” 1 Installation Instructions 1 USE Installation of kit Read before installing Description Installation This kit is designed for use with a 48” snow/dozer blade, Model No.
PAGE 2
3. On the left hand frame rail position the guide flush with the inside edge of the rail and 2 1/2” (64 mm) from the back edge of the pivot plate (Fig. 1). 4. Clamp the guide to the frame member. Using the guide as a template, drill two 3/8” diameter holes. 5 3 1 2 6 9 10 7 8 4 m–4406 Figure 1 1. 2. 3. 4. Stabilizer Stabilizer arm Frame Screw, 5/16 x 1 1/4” (32 mm) 5. Screw, 3/8 x 1” (25 mm) 6. 7. 8. 9. 10. Guide Nut, 3/8” Nut, 5/16” 2 1/2” (64 mm) distance Flush edges 5.