Installation Instructions

The Toro Company – 1999

Printed in USA

FORM NO. 3322-866

INSTALLATION

INSTRUCTIONS

PART NO. 100-3390

REAR ATTACH–A–MATIC HITCH

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Mounting bracket assembly

Mounting bracket

Locknut 3/8–16

Carriage bolt 3/8–16 x 3 1/2” (89 mm)

Assemble Attach–A–Matic

Assembling the Rear

Attach–A–Matic Hitch

The rear Attach–A–Matic is mounted on the rear

axle of the tractor.

1. Push one bolt upward through the rear hole on

each side of the Attach–A–Matic, then through

a mounting bracket (Fig. 1).

m–4493

Figure 1

1. Facing front of tractor

2. Facing rear of tractor

3. Mounting bracket

4. Carriage bolt,

3/8–16 x 3 1/2” (89 mm)

5. Locknut, 3/8”

6. Latch

PAGE 1
FORM NO. 3322-866 REAR ATTACH–A–MATIC HITCH INSTALLATION INSTRUCTIONS PART NO. 100-3390 Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Mounting bracket assembly 1 Mounting bracket 2 Locknut 3/8–16 4 Carriage bolt 3/8–16 x 3 1/2” (89 mm) 4 USE Assemble Attach–A–Matic Assembling the Rear Attach–A–Matic Hitch 3 6 The rear Attach–A–Matic is mounted on the rear axle of the tractor. 1.
PAGE 2
Installation Instructions 2. Begin to thread a locknut onto the end of each bolt (Fig. 1). 5. Tighten the nuts evenly on the bolts to hold the Attach–A–Matic in place. 3. Place the Attach–A–Matic under the rear axle (Fig. 2), and rotate the mounting brackets over the top of the axle to hold the Attach–A–Matic in place. 6. 4. Push the remaining two bolts upward through the front holes on the Attach–A–Matic , then through the remaining holes on the mounting brackets.