Installation Instructions
Installation Instructions
2
4. Thread an adapter into both the new male and female,
flush-face couplers (Fig. 1).
2
1
3
Figure 1
1. Adapter
2. Female, flush-face coupler
3. Male, flush-face coupler
5. Torque the adapter/coupler assemblies to 100 ft-lb
(135.6 N⋅m).
6. Remove the old female coupler from the hose.
7. Install the female coupler assembly onto the hose as
follows (refer to Figure 2 during this procedure):
For Kit Number 100-4744 and 100-4750:
• Thread the assembly onto the hose end.
• Torque the assembly to 60 ft-lb (81 N⋅m).
For Kit Number 100-4746 and 100-4751:
• Thread the assembly onto the hose end.
• Torque the assembly to 67 ft-lb (90 N⋅m).
For Kit Number 100-4745:
• Clean all old pipe thread sealant from the threads
on the hose.
• Apply pipe thread sealant to the hose threads.
Do not apply sealant to the first thread.
• Thread the assembly onto the hose end until it is
finger-tight.
• Turn the assembly onto the hose end 2 to 3
complete turns.
• Allow the sealant to cure according to the
manufacturer’s instruction before using the
attachment.
m–4764
1
3
2
Figure 2
1. Coupler assembly
2. Hose end
3. Protective cover (traction
units only)
8. Repeat steps 6 and 7 to install the male, flush-face
coupler.
9. If you are installing a kit on a traction unit, install the
protective covers onto the couplers (Fig. 2).
10. Wipe up any spills.