Installation Instructions

The Toro Company – 1999

Printed in USA

FORM NO. 3323-325

INSTALLATION

INSTRUCTIONS

PART NO. 100-6097

SEAT KIT

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Seat (includes switch)

Adapter wire

Install seat

Installation instructions 1 Read before installing

This seat is designed to replace seats on older model

tractors utilizing a different version of a seat interlock

switch. Some modification, using the adapter wire, is

necessary to update to this assembly.

Assembling Seat to Tractor

Remove Old Seat

1. Disconnect the seat switch wire at the connector

under the seat. Remove the seat. If seat

adjusters were installed, remove them and install

on the new seat.

2. Remove the connector from the tractor wiring

harness by cutting the wires at the connector

(Fig.1 ).

3. Strip the insulation back on each wire

approximately 1/4” (Fig.1 ).

4. Install the wire harness adapter by sliding the

wire connectors onto the stripped ends and

crimping with a pair of wire crimpers (Fig. 1).

PAGE 1
FORM NO. 3323-325 SEAT KIT PART NO. 100-6097 INSTALLATION INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Seat (includes switch) 1 Adapter wire 1 Installation instructions 1 This seat is designed to replace seats on older model tractors utilizing a different version of a seat interlock switch. Some modification, using the adapter wire, is necessary to update to this assembly. USE Install seat Read before installing 4.
PAGE 2
Installation Instructions 1 5 4 3 2 m–4520 Figure 1 1. Seat switch lead 2. Adapter wire 3. Tractor wire harness (end connector removed) 4. Stripped ends 5. Crimp connectors Install New Seat 1. Install the new seat using the hardware from the old seat. 2. Connect the seat switch to the adapter, added to the tractor wire harness. 3. Check the seat for proper function as described in the tractor Operators Manual.