Installation Instructions

1
All Rights Reserved
Printed in the USA
 2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Form No. 3326-977
Installation
Instructions
Part No. 104–4869
Rear Roller Scraper Kit
Groundsmaster

3500–D
1. Position the machine on a level surface, lower cutting
decks, stop engine, engage the parking brake and
remove key from ignition switch.
2. Remove and retain mounting screws securing roller
mounts to rear of deck frame (Fig. 1). Remove and
discard roller, scraper, roller mounts and all remaining
mounting components.
3
4
2
1
Figure 1
1. Mounting screws
2. Roller mount
3. Rear roller
4. Scraper
3. Insert a roller mount onto each end of roller shaft.
4. Thread a nut onto each long capscrew supplied in kit.
5. Loosely mount each end of scraper and a scraper plate
to each roller mount with a short capscrew and a long
capscrew/nut as shown in figure 2.
6. Rotate roller until flat on roller shaft is aligned with end
of long capscrew. Tighten long capscrew.
1
2
3
6
4 55
Figure 2
1. Rear roller
2. Scraper
3. Roller mount
4. Scraper plate
5. Upper screw
6. Lower screw
7. Insert roller mounts into rear of deck frame and loosely
secure with 2 mounting screws previously removed.
8. Slide the scraper up or down until a gap of .02–.04 in. is
achieved between the rod and the roller. Tighten short
capscrew and jam nut to lock adjustment. Torque to
30 ft.-lb. (41 N⋅m).
9. Secure the remaining mounting screws to 30 ft.-lb.
(41 N⋅m) in an alternating sequence.