Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 104-6953

Printed in the USA

 2002 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Signal Light Kit

Workman



1100/2100 and Twister Utility Vehicles

Part No. 104-6953

Form No. 3326-969

Installation Instructions

Note: You must have the Brake and Tail Light Kit, Part No. 104-6697, installed to operate this kit.

Loose Parts

Description Qty. Use

Signal controller

Grommet

Wire tie

Installing the signal controller

Signal light

Pan head screw, 1/4 x 1 in.

Flat washer

Locknut

Wire tie

Installing the signal lights

Installing the Signal Controller

1. Position the machine on a level surface, stop the

engine, and remove the key.

If you leave the key in the ignition switch,

someone could accidently start the engine and

seriously injure you or other bystanders.

Remove the key from the ignition switch before

you do any maintenance.

Caution

2. On the top edge of the dash, mark the location of the

signal controller wire harness as shown in Figure 1.

3. Remove the hood from the vehicle by removing the 2

screws on top of the hood, the 2 bolts on each fender,

and the 4 bolts from the bottom of the hood.

4. Drill a hole (3/4 in.) and slot (3/8 in. wide) in the dash

(Fig. 1).

5. Slit one side of the grommet and slide it over the

signal controller wire harness.

m–5880

Figure 1

1. Harness location 2. Hole & slot

6. Attach the signal controller to the steering column as

follows:

A. Insert the screws into the anchors.

B. Insert the assembled anchor screws into the slots in

the signal controller. Do not tighten.

C. Cut the strap included with the signal controller to

4-1/2 in. (114 mm) long.

Summary of content (4 pages)

PAGE 1
Form No. 3326-969 Signal Light Kit Workman 1100/2100 and Twister Utility Vehicles Part No. 104-6953 Installation Instructions Note: You must have the Brake and Tail Light Kit, Part No. 104-6697, installed to operate this kit. Loose Parts Description Qty. Signal controller 1 Grommet 1 Wire tie 1 Signal light 2 Pan head screw, 1/4 x 1 in. 4 Flat washer 4 Locknut 4 Wire tie 2 Use Installing the signal controller Installing the signal lights Installing the Signal Controller 1.
PAGE 2
D. Insert one end of the strap through the clip of the signal controller and bend the strap 1 inch (25 mm) from the end. Catch the clip under the anchor on the controller (Fig. 2). 3 2 1 Figure 4 1 2 3 1. Taillight harness 2. Cap/Signal controller harness 4 Figure 2 1. Screw 2. Anchor 3. Clip 4. Strap 3. Open plug 9. Fold the remaining wires of the signal controller harness behind the dash and secure them with a wire tie. E.
PAGE 3
1 Figure 6 Twister 1. Signal light 2. Remove the lens from the signal lights. 3. Remove the bulb and attach each signal light to the hood with 2 screws, washers, and locknuts. 4. Install the bulb and attach the lens. 5. Plug the short end of the signal harness into the left signal light. Plug the long end of the harness into the right signal light. 6. Secure the signal harness to the vehicle headlight harness with 2 wire ties. 7.
PAGE 4